¶ Node Pro Change SD Plug
Some 3D printers have different batches of motherboards. In order to make Node Pro adapt to SD card slots of 3D printers from different manufacturers, sometimes it is necessary to replace the SD card plug of Node Pro.
¶ Select the resistance value of the SD plug
As shown in the figure on the right, put the DIP switch 1 in the on state
Only set one dial to on state at a time
- GD32(Ender3 Pro) chip, please set 3 to on state
- Kobra Go please set 2 to on
- Kobra Neo please set all to on state
- For other 3D printers, set 2 to on
¶ Remove the old SD plug from the robin
As shown below, remove the old SD card plug from the flexible cable:
¶ Get your new SD card plug ready
¶ Install the new SD plug
Congratulations, you have completed the replacement!