¶ PrusaSlicer upload gcode file to Node Pro
Node Pro implements Octoprint's file transfer protocol.
Thanks to Octoprint for open source, Node Pro can realize PrusaSlicer to transfer files directly to SD card.
Make sure your firmware version is 2022-9-29-2007 or newer
¶ Physical Printer Settings
Make sure your PrusaSlicer's version is higher than 2.4.0
Follow the 4 steps on the right to enter the setting interface of Physical Printer.
¶ Set Node Pro's IP
Give your Node Pro a name and select the Host type as "Octoprint"
Get the Node's IP address from the Node's OLED display, and then fill it in the position shown on the below 1 2
After clicking "Test", PrusaSclicer will perform a connection test. After clicking, the prompt shown in the picture below on the right will appear, indicating that the connection is successful.
¶ Slice and upload gcode file to Node Pro
If everything is normal, after the slicing is completed, click the icon pointed to by 1 in the right image, and a dialog box for modifying the file name will pop up.
After clicking "Upload", start uploading the gcode file.
As shown below, after "COMPLETED" appears at the bottom, the file transfer is complete:
